Surface energy analysis of Ti₃SiC₂ deposited steel substrate using contact angle measurements

Authors

Hamdi Muhyuddin Barra Physics Department, Mindanao State University, Marawi City
Henry Ramos National Institute of Physics, University of the Philippines Diliman

Abstract

Deposition of the MAX phase compound Ti₃SiC₂ onto stainless steel substrate using the sheet plasma negative ion source (SPNIS) was investigated through the calculation of surface energy. An optical microscope was used to measure contact angles of static liquid drops onto the samples and the van Oss-Chaudhury-Good method was employed to calculate the surface energy. Three samples were prepared with differing CH₄:Ar ratios of 1:4, 1:5 and 1:8. Results showed that Ti₃SiC₂ deposit increased the hydrophobicity of the stainless steel. As the ratio of the gases increased, the substrate became more hydrophobic. The sample with 1:4 gases ratio displayed high hydrophobicity with a maximum static water contact angle of 100.070. Finally, the surface energy of the MAX-phase coated stainless steel was noticeably decreased compared to the uncoated surface.

Downloads

Issue

2013: Proceedings of the 31st Samahang Pisika ng Pilipinas Physics Congress

Article ID

SPP2013-PA-32

Section

Poster Session PA

Published

2013-10-23

How to Cite

[1]

HM Barra and H Ramos, Surface energy analysis of Ti3SiC2 deposited steel substrate using contact angle measurements, Proceedings of the Samahang Pisika ng Pilipinas 31, SPP2013-PA-32 (2013). URL: https://proceedings.spp-online.org/article/view/SPP2013-PA-32.